How to use frame straightener scissor lift?

Keywords: auto body frame machine, car Rotisseries,scissor lift, frame straightening machine,spray painting booth, spray tan booth

(1) Drive the car on the top of the bench.

a. Put Four bigger ramps on both sides of bench,and put two small ramps for driving the car onside;
b. Stop the car until wheels get the point where the braket is,which is used to prevent cars driving off the bench.
(2) Lifting the car up
a. Put 4 lifting long beams and 4 rubber pads under the car;
b. Press bench”up” on the cabinet or remont to lift the car up.
(3) Ramp folded up to hold car types
a. Fold up four bigger ramps and locked automatically;
b. Press bench”up” to lossen the locking block, then press the “unlock” & “down”
at the same time,stop when four tyres put on 4 stands(ramps stands).
(4) Main clamps assembly
a. Put 4 holding beams on the bench;
b. Put 4 clamps on the holding beams and fix each screw.
(5) Put full set pulling arms on the bench
a. Put height measuring leg on the ground , the ground should be flat, so the pulling arm can be pushed into the bench exactly.
b. Put on the down-pulling device and make the chain going through it and hook the car.
(6) Bench is portable with car.
a. Press “ basement” signal, then “up”, so the basement can leave the floor and put back.
b. More the whole system anywhere.

Last text: How to use plastic hot stapler?
Next text: Our customers who are from Germany come to visit our factory