How to use plastic hot stapler?

Preparing the plastic:                                                          
Make sure the area to be stapled is free of paint and clean.
Remove any oils or residues from the plastic’s surface.       
              
 
Getting Started:
Plug in the control box and turn on. Carefully insert desired staple into one of two possible positions in the end of the stapler without depressing the power button on the handle.Once pressed to bottom of the hole , the unit is ready for use.
 
 
 
Setting the Temperature:
Turn the control dial to the second or third position,unless very low heat levels are desired.These two positions satisfy most stapling applications.
 
 
Use:
Lay staple over the desired location and apply gentle pressure.Push the button on the handle, then release once the staple is at the desired depth.Allow to cool slightly.Pull back and the staple will remain in the plastic.Clip off the staple with the supplied diagonal cutter.
 
 
Caution:
When clipping off the staple prongs,wear eye protection and cup your hand over the staple to prevent the clipped wire from becoming a projectile.